Hi, Its been a while

[mac007]

I recently had lightscribe installed. Everything was working fine. I went and upgraded my Nero from 6.3 to 6.6. Now, when I try to burn a movie, I am getting: Error:\n cannot connect TRF. I re-installed 6.3 again. I use AnyDVD, Shrink and Nero and I never had a problem till now. I also looked at my files being saved and they are mostly mpeg files. I have 2 drives so once I start I just let it go and it usually finishes. Each file type has a symbol like the power dvd symbol next to it. Thank You for any help that you can give


VTS
MPEG File VTS
IFO File

Video_TS.BUP
BUP File

VTS
MPEG File

[jm1647]

If you upgraded to 6.6.1.4 download to 6.6.0.18, get it here.

http://forum.digital-digest.com/showpost.php?p=361020&postcount=1

[mac007]

Thanks Alot, used the clean tool, installed the 6.6.0.18 and everything is fine-----------------Thank You

[mac007]

Back to the drawing board

I used the clean tool to remove 6.6.1.4. I installed 6.6.018. Everything was fine. I checked the nero version#, it was 6.6.018. I installed LightScribe, I checked the verson # of nero again and it went up to 6.6.1.4. I tried to burn with shrink and got the same trf message. Is there anything I can do. I have nero 6.3 bundled. I can re-install it. But will I have the same problems??????
Thanks

[soup]

Use the clean tool to remove Nero, then reinstall your bundle & then update to this. You could always use this version of Dvd Shrink that burns with ImgBurn but install ImgBurn first.

[mac007]

Finally Figured it out

Nero 6.6.018 was fine. But after I installed LightScribe, the Nero version jumped back up to Nero 6.6.1.4. The solution is, when you are installing LightScribe, install everything on the disc, except the Nero. Everything is fine. Thank all of you for all of your help