Custom menu not exported correctly in DVD Remake Pro

[blutach]

@dimad

I have merged 3 small DVDs together with DVD Remake Pro and, of course, it went like a charm.

That's the good news.

I followed this guide to adjust the menu, including creating a little DVD with muxman (my menu background is VTST 1, 1). After step 6, my new menu (which is based on your DRMP_M3_PAL.bmp) looks great in VTSM 4, 1. (Note the little bug: VTST 4, 1 is in NTSC, but since it is unreferenced, I don't think it matters).

Now, I go to export and the export finishes but the VTSM 4,1 menu can not be decoded properly. PgcEdit's preview shows the lower half of the screen is all green. All software players I have hang on it.

I have noticed the size of the original DVDRMP menu is 42k (the one with "> Disk 1 > Disk 2 > Disk 3" on it) and, strangely enough, is also 42k in the one which I exported where the block was replaced with a still (the title authored in muxman was 98k without the subtitle pack).

I exported 3 times to be sure. Is this a known bug?

Thanks for your advice.

Regards

[dimad]

Is this a known bug?

Probably it is the same as: http://cdr-zone.com/forum/viewtopic.php?t=4998

Are you also replace menu on previously exported and later imported merged disk?

[blutach]

Yes, that's what happened. I exported my triple project and saved (with the default "title menu" in VTSM 4,1). Then decided I wanted to change it as per that guide. So I re-imported and then changed the block and re-exported and ran into problems.

I hope you track down this little problem.

PS. About the NTSC in VTST4,1 - do you think DVD Remake Pro should detect it is a PAL DVD and make a PAL frame accordingly?

Regards

[dimad]

DvdReMake Pro v3.4.2 should fix the problem.

PS. About the NTSC in VTST4,1 - do you think DVD Remake Pro should detect it is a PAL DVD and make a PAL frame accordingly?

Yeah, it is not critical, but is not right - so will be fixed in one of the next versions.