burned a bunch w shrink but now getting file errors. ps help.

[johnsnow]

Hello:

I'm hoping someone can help me. I've had a lot of success burning DVD's using Shrink 3.2 and CopytoDVD (purchased it too!).

The last several movies I burned seemed to shrink great! During the write phase, the movies fail. I'm not sure why. I've played with the settings in both programs and nothing seems to help. I've even tried Decrypter, then Shrink, and Then CopytoDVD and still the same write errors. Below are the primary problems that I've seen when I opened the log file.

Code 00 00 00 [No sense information.]

Code 06 29 00 [Unit attention, Power On or Bus device reset occured]

I attached the log file if that helps clarify.

Any help would be greatly appreciated.

Thanks


John

[setarip]

Sounds like your burner is faltering or failing...

[johnsnow]

how do I find out if this is the case?

[charlypuss]

had a look through your log file and found this:

1/16/2005 10:34:32 AM info Writing speed requested x16.0, effective x3.0
1/16/2005 10:34:32 AM info Writing session #1 and closing disc.
1/16/2005 10:34:32 AM info Open Image file "C:\MAGDALENE_SISTERS.ISO"
1/16/2005 10:34:32 AM info Available sector size : 2297888
1/16/2005 10:34:32 AM info Media ID: RITEKG05
1/16/2005 10:34:31 AM info 120mm DVD Single Layer
1/16/2005 10:34:31 AM info Detected media $0011: DVD-R
1/16/2005 10:34:29 AM info Using ISO image writing mode.
1/16/2005 10:34:29 AM info Start Browsing file structures
1/16/2005 10:34:29 AM info IDE Controler manufacturer : Silicon Integrated System
1/16/2005 10:34:29 AM info IDE Controler Description : SiS PCI IDE Controller
1/16/2005 10:34:29 AM info Supported Media: DVD-R, DVD-RW Seq., DVD-RW RO, DVD+R, DVD+RW, CD-R, CD-RW, DL DVD+R
1/16/2005 10:34:29 AM info Writing device used: 1:0:0 - 16X8 DVD DUAL A04b [D] (Ide)



All the way through your log you have requested different speeds but it seems to default to 3X. Now i have not had much experience with the burning prog you are using, but the fault may lay in the drive settings.. Possibly the DMA settings have gone to PIO..
Or possibly your burning program has had a fit ....