If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
ok open TMPGEn, file, MPEG tools, Cut and Merge.
cAdd my M2v file, clicked edit, set the in and out points, clicked ok.
Then set output file name, then click ok
The "TYPE" drop down box at the top has 2 MPEG 2 settings one is Svcd, obviously dont want that, the other is MPEG 2 (VBR)
which (if any) do i select here?
I tried the (vbr) one and it created an MPEG file, not an M2v, and the MPEG file it created was kinda squashed up , long and thin looking.
1.is there any other settings i have to set in the programme?
2. How do i make it create an M2v file instead fo the MPEG file
3. Whats causing the wrong aspect ratio??
thanks again
SI
Comment