If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Assuming that A) you've installed the MPEG2 VFAPI plugin(available at DVD Digest downloads site), which allows reading of MPEG2 files, and B) you are asking about simple MPEG2 files (NOT SVCD-formatted from a CD), the procedure is as follows:
1) File>>MPEG Tools>>Merge&Cut
2) Set mode to MPEG2
3) Load your file
4) Doubleclick on your loaded file name
5) Move slider to desired ending time point for first half
6) Click on "}"
7) Enter new name for output of part 1 file (e.g. "Part1of2MPEG2.mpg")
8) Press "Run"
9) Again, doubleclick on your loaded file name
10) Copy time from right side box to left side box
11) Move slider to far right end
12) Click on "}"
13) Enter new name for output of part 2 file (e.g. "Part2of2MPEG2.mpg")
14) Press "Run"
yes yes yes ther may be light at the end of the tunnel 1st i have not installed plugin ( i have just try down loading but to much trafic when i do getplugin what do i do with it pardon the pun ) thank you setarip
abdul thanks 4 being patient with me i have not had a puter 4 long so i am very new 2 all of this, setarip was right i did not have the plugin ,now i have it a zip file i have un ziped it in the same folder as tmpeg wich then gove me a folder called
m2v_vfp0.4.6 is this right so far ? then what do i do sory for being stupid but i am new boy 2 computers i feel i am so near to sorting this out i do not wish 2 give up
Comment