HELP- message says 'paging file is too small '

[haloslippingdow]

at 87% of my dvd i get a message 'the paging file is too small for this operation to complete ' ALSO
get message 'virtual memory too low'
HOW CAN I CORRECT BOTH OF THESE PROBLEMS---PLEASE HELP
greatfully yours in advance......dave

[LT. Columbo]

"paging file is too small"
look here:

http://forum.digital-digest.com/showthread.php?t=53830&highlight=paging+file+small

by cynthia:

Virtual memory warning

Error code ver 3.2:

Virtual memory warning

Problem:

On some DVDs when you try to use DVD Shrink you get the error code above and it stops encoding. You also notice that the buffered amount goes through the roof. You have 256 MB RAM installed. Credit: apc_fan

Solution:

Some DVDs with multi-angle features, long chapters or high bitrates will require more memory than that. Memory is cheap these days. Get another 256MB! (or increase your swap file size, but expect a severe performance penalty if DVD Shrink starts using swap file). Credit: dvdshirnk

When you get virtual memory warning, it is more likely that your harddrive doesnot have enough space. When encoding it will takes 1.5 x 9.0GB (duala layers)/4.5GB(single layer) original DVD of your HD (where you store the outout file).
-You should clean up your output files to free up space on your HD, and/or
-Use same output file folder (overwrite the old out put file) and/or
-Go to "System Property" -> "Performance Options" to increase the virtual memory capacity to the maximum available. Credit: vitieubao0223

[jm1647]

Also check out recommendations for pagefile/swap file here