Tweet
XMpeg 'GetFrame' Error
I've used this technique previously, but now it is causing problems. Any advice?
I'm using XMpeg with the Premier Video Server and the AVIWrapper to encode directly from VOB to MPG with CCE2.62. I'm using 3 pass VBR and CCE generates the VAF file fine. After the first MPV pass, though, I get the following error:
"Error with GetFrame Call"
It happens right at the end of the pass, when CCE should be requesting the first frame to start the next pass.
Thanks for your help,
Joe
P.S. Could it have to do with the number of frames I am encoding? In XMpeg (on the General tab under Global Output Options), you can't check "Whole File" with the Video Server. XMpeg gives a warning about entering the exact number of frames. I've been encoding the number of frames reported by DVDx minus 2 frames. Is that wrong?
I'm using XMpeg with the Premier Video Server and the AVIWrapper to encode directly from VOB to MPG with CCE2.62. I'm using 3 pass VBR and CCE generates the VAF file fine. After the first MPV pass, though, I get the following error:
"Error with GetFrame Call"
It happens right at the end of the pass, when CCE should be requesting the first frame to start the next pass.
Thanks for your help,
Joe
P.S. Could it have to do with the number of frames I am encoding? In XMpeg (on the General tab under Global Output Options), you can't check "Whole File" with the Video Server. XMpeg gives a warning about entering the exact number of frames. I've been encoding the number of frames reported by DVDx minus 2 frames. Is that wrong?