Tweet
Hi everybody,
I hope someone will share experience about the following.
Normally after the burn I test DVDRs by running in PowerDVD on x32 speed. If it runs OK from the beginning to the very end, it is usually good and plays in my standalone (at least most of them). Also, if I try to skip chapters and it stops - it means there are errors. But sometimes it happens that DVDR won't run x32, but shows no errors on x4. In this case standalone playability is questionable: most play, some do not.
Anybody has explanation for the above? I am asking, because I am not sure what to do about those playable DVDRs: should I try to make another copy that is 100% error-free to avoid problems in future or may be just ignore those errors on x32 f/f playback?
I'll appreciate comments and help.
Brenda
I hope someone will share experience about the following.
Normally after the burn I test DVDRs by running in PowerDVD on x32 speed. If it runs OK from the beginning to the very end, it is usually good and plays in my standalone (at least most of them). Also, if I try to skip chapters and it stops - it means there are errors. But sometimes it happens that DVDR won't run x32, but shows no errors on x4. In this case standalone playability is questionable: most play, some do not.
Anybody has explanation for the above? I am asking, because I am not sure what to do about those playable DVDRs: should I try to make another copy that is 100% error-free to avoid problems in future or may be just ignore those errors on x32 f/f playback?
I'll appreciate comments and help.
Brenda