I'm a newbie at cutting with VobBlanker, (this is my first time), I followed the guide provided at:
But the problem I'm running into is that when I open up the "preview/cut" mode, the buttons for "mark" and "clear" on the right-hand side are grayed out and cannot be pressed. I try to enter a Cell# and a sector (Iba) but it will not allow any inputs. I try sliding the bar back and forth and I can see the DVD, but I can't use the mark features. What am I doing wrong?
It is importatnt to note that I just upgraded to the new VobBlanker 2.1.1.ORC1, but I have never tried to preview/cut before so I don't know if it has anything to do with the new version. I suspect I'm the one at fault and am doing something totally stupid. Please help!
But the problem I'm running into is that when I open up the "preview/cut" mode, the buttons for "mark" and "clear" on the right-hand side are grayed out and cannot be pressed. I try to enter a Cell# and a sector (Iba) but it will not allow any inputs. I try sliding the bar back and forth and I can see the DVD, but I can't use the mark features. What am I doing wrong?
It is importatnt to note that I just upgraded to the new VobBlanker 2.1.1.ORC1, but I have never tried to preview/cut before so I don't know if it has anything to do with the new version. I suspect I'm the one at fault and am doing something totally stupid. Please help!
Comment