Tweet
I'm starting to think you got a bum drive, IF you actually uninstalled and cleaned Nero as I suggested. Most of the errors are either stating the disc isn't formatted or is incompatible media.
I can only think of a couple more suggestions, One is to make sure the power supply 12v isn't too low. Switch the power lead with another device preferrably one that isn't shared with ANY other devices. Also might be a good idea to use a utility to monitor voltages, some mobo manufacturers supply one with the boards & drivers.
Two is to try reflashing the firmware.. could be a bad flash. Three is to try burning with Imgburn or DVD Decrypter to take Nero out of the picture.
Finally if nothing else works, read the instructions here and download Force ASPI I recommend using ForceASPI this way:
* Run dumpASPI to backup your current ASPI layer
* Run killASPI
* Run instASPI to install the new ASPI layer
* Reboot
* Run aspichk or Nero Info Tool to see if everything worked OK
If none of that works, perhaps it's a bum drive. Any read problems?
I can only think of a couple more suggestions, One is to make sure the power supply 12v isn't too low. Switch the power lead with another device preferrably one that isn't shared with ANY other devices. Also might be a good idea to use a utility to monitor voltages, some mobo manufacturers supply one with the boards & drivers.
Two is to try reflashing the firmware.. could be a bad flash. Three is to try burning with Imgburn or DVD Decrypter to take Nero out of the picture.
Finally if nothing else works, read the instructions here and download Force ASPI I recommend using ForceASPI this way:
* Run dumpASPI to backup your current ASPI layer
* Run killASPI
* Run instASPI to install the new ASPI layer
* Reboot
* Run aspichk or Nero Info Tool to see if everything worked OK
If none of that works, perhaps it's a bum drive. Any read problems?
Comment