Audio and Video not Synchronized after burning

[asjt3]

Hey guys,

After converting and subsequently burning a divx avi movie into DVD, when I play the DVD, the audio and video are not synchronized. I used avi2dvd to convert, and I used the FreeEnc. Think that might have been the problem? I burned the DVD using Nero Express.

[LT. Columbo]

it's most likely the file at fault. is it out the same amount at any given point of the clip?

[asjt3]

it's most likely the file at fault. is it out the same amount at any given point of the clip?

Nope

[LT. Columbo]

try this, then convert this newly made file. it must be VBR audio?

change the audio to a .WAV file using Virtualdub. Load the file. Go to "video">Direct stream copy. Under "audio">full processing mode, Click "audio" again. click Conversion check 48,000Hz and check "high quality" and ok. Go to "audio" >compression, select "no compression" (PCM) and ok. Finally go to FILE> save WAV. this will produce a .wav file (audio only).


when its done, load the original avi file again under file. go under audio, select full processing mode, go to audio again, select wav audio. load the wav file you made earler.

under video select direct stream copy, under audio, "full processing mode">compression>i use LAMEmp3 CBR>file>save as avi.