DVDRMP Insignificant Errors?

[idontno]

Now what would cause this? I got this after killing a bunch of useless/blank pgc's. I just wanted to tidy up. They all were 0.03 MB. The list goes down to 19. I just deleted all that were red....



And why are some lines highlighted in green?

.

[blutach]

Note precommand 2. It jumps to VMG. Assuming precommand 1 didn't jump over it, everything after it is rubbish which can not be executed.

As well, in DVDRMP, if you select a command that has a goto statement, the goto destination's line number is highlighted in green. So, pre 1 might have jumped to pre 3 (conditionally most likely).

Regards

[r0lZ]

0.01MB! Obviously, this PGC has been killed or blanked. Therefore, I suppose blu is right, and the LinkPG commands cannot be played.

[idontno]

Yes you're right. Pre 1 does have a goto line 3 command. And it does turn green if the goto command is highlighted. I didn't know this.

As far as the red program links go, when I mouse over them it says "Reference to program 'number' while there are only 1 program(s) available.".

I take this to mean they are wanting to link to a non-existant program and are safe to delete. Right?

.

[r0lZ]

Well, I'm not totally sure, as I can't see the post and cell commands, but anyway, since these commands are illegal, yes, it is probably better to delete them.

[idontno]

My policy is to set PUOps in all menus (via PgcEdit's PUO plugin) to 192. Where there are intros and outros (I rarely keep the latter), I author an invisible button with Link Next Cell (intros) or Link Tail PGC (outros). That way, it's always a button that makes something happen and I don't have to hang around for stupid intros to finish.

Do you set your PUOps to 192 with the [Value input] button? If so, how do you know which PUO you changed?




.

[idontno]

Well, I'm not totally sure, as I can't see the post and cell commands, but anyway, since these commands are illegal, yes, it is probably better to delete them.

Post command is... Call "root" menu (Resume cell1)

Cell command is... LinkTailPGC

.

[r0lZ]

OK, no problem then! Remove the LinkCN commands.

[blutach]

Do you set your PUOps to 192 with the [Value input] button? If so, how do you know which PUO you changed?




.

I do it with the PUO plugin - set PUOs for the domain. Does it for all PGC in the menu domain for that VTS in one edit.

Regards