Ok...I'll attempt to the best of my ability to keep this short. This morning at 4am, I awoke to hp updates on my screen. I hit yes to install them and went for a cup of coffee. I come back and it says complete...and restart? I click yes and run to the bathroom. I come back and my cd rom is open. I close it and it opens again....and again...and again.
I contact HP and they give me a couple non-solutions and tell me they will escalate the situation after telling me it's probably a hardware issue and if not I should probably just do a system recovery!
Okay... I know it's not the hardware and are you kidding me?
System Recovery!!!?
Ok..so I'm livid now. I start researching it myself and end up here at your site. On one of the entries I see someone who's helping another person with something similiar saying to check the system logs and application logs. So I see exactly what I thought, but I can't make heads or tails of it. I had no problems AT ALL in there until the update. Now ERROR, ERROR, ERROR.
Some of the errors are as follows....
1) ftsata2 error - failed to load
2) DCOM error - service cannot be started
3) SideBySide error - Generate Activation Control Context error
There are several of the SideBySide errors showing up including something called Resolve Partial Assembly failed for VC80.CRT The reference assembly is not installed on system.
I am at a stand still with this and my cd rom is still open.
I am livid. I take good care of my pcs and the HP techs are so completely incompetent.
Can someone pretty please help me?
Thank you all....
I contact HP and they give me a couple non-solutions and tell me they will escalate the situation after telling me it's probably a hardware issue and if not I should probably just do a system recovery!
Okay... I know it's not the hardware and are you kidding me?
System Recovery!!!?
Ok..so I'm livid now. I start researching it myself and end up here at your site. On one of the entries I see someone who's helping another person with something similiar saying to check the system logs and application logs. So I see exactly what I thought, but I can't make heads or tails of it. I had no problems AT ALL in there until the update. Now ERROR, ERROR, ERROR.
Some of the errors are as follows....
1) ftsata2 error - failed to load
2) DCOM error - service cannot be started
3) SideBySide error - Generate Activation Control Context error
There are several of the SideBySide errors showing up including something called Resolve Partial Assembly failed for VC80.CRT The reference assembly is not installed on system.
I am at a stand still with this and my cd rom is still open.
I am livid. I take good care of my pcs and the HP techs are so completely incompetent.
Can someone pretty please help me?
Thank you all....
Comment