audio out of sync using TMPGEnc

[staple]

ive downloaded a svcd movie burnt onto a cd
plays on my comp +dvd player without probs

but when i merged both files together using tmpgnc the sound goes out of sync on the second half of the movie

so i used another mpeg joiner the sound is great but the pic jerks
i'm trying to convert the files to burn on a dvd

any advice on this please

[setarip]

"but when i merged both files together using tmpgnc the sound goes out of sync on the second half of the movie"

You can resynch the MPEG2-SVCD file as follows:

1) Load it into TMPGEnc

2) Set mode to "MPEG-2SuperVideoCD"

3) From under the "Advanced" tab, put a checkmark next to and then double click on "Source Range". Select start and end positions for the portion that needs to be adjusted

4) Enter an appropriate positive or negative ("-") amount of milleseconds (thousandths of a second) next to "Audio gap correct"

5) Save with a new filename

Let us know of your success ;>}

[staple]

thanx for the quick reply
ive loaded the merged file to try wasn't to sure if i was suppose to use cd2 only


1) Load it into TMPGEnc where do i load it on the front page after canceling wizard if so i tried that

2) Set mode to "MPEG-2SuperVideoCD" ok i went into settings at the bottom right corner
then video stream changed to mpeg-2video

From under the "Advanced" tab, put a checkmark next to and then double click on "Source Range". Select start and end positions for the portion that needs to be adjusted

i ticked Source Range

4) Enter an appropriate positive or negative ("-") amount of milleseconds (thousandths of a second) next to "Audio gap correct"

done then pressed ok

5) Save with a new filename i saved the file but not sure what to do now
i did press start but came up with an error i aint got no mpeg 2 player installed


i hope you can still help me out not sure if ive made a mess of things

[staple]

any more advice on my problem please