TMPGEnc a/v ?!!

[miso]

did u try this? :

with Virtual dub take the movie file and strip it into a wave file and an avi file - direct stream without sound.

check your video framerate(should be 24 fr/sec),then with TMPEGenc encode it as NTSC film(for 24fr/sec mpg).Don't use any multiplex!! since the seperate audio and video files are the same length they'll be in sync.

if that doesn't work, i'm outta ideas.

[techno]

thanks for ur time and kind reply Miso, it is appreciated

I already tried this one, sorry! But thank-you, if u have any more ideas, please, post em here!

[Enchanter]

Re: Setarip

Turn on your PM system and I'll give you the answer I was going to give you on the other thread (before it was closed).

[techno]

hmm.....

I hope this works, because I encoded about a mintues worth of video and seems fine.

stripped out the wav, leave it as it was 48000Hz Sampling rate, then load in the video in TMPGEnc and load in this wave in the audio source, then selected a part (about 5-9 mins now) in the source range settings in TMPGEnc and it is encoding now, I hope it works.

It worked fine when I encoded about 1 mins worth, but then again, it could go out of synch later on in the video.

[techno]

well that did work! so now I am doing the full thing.


now back to this buggy problem.

this video file that is causing the problem has this info:

23.976fps
Audio = 44100Hz

Now, since the other video had the same info, but the audio was 48000Hz and seemed to work fine when encoding to VCD, do u think I should "upsample" the 44100Hz to 48000Hz? Do you think it would work?