Hi, Its been a while

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • mac007
    Junior Member
    Junior Member
    • Apr 2006
    • 26

    Hi, Its been a while

    I recently had lightscribe installed. Everything was working fine. I went and upgraded my Nero from 6.3 to 6.6. Now, when I try to burn a movie, I am getting: Error:\n cannot connect TRF. I re-installed 6.3 again. I use AnyDVD, Shrink and Nero and I never had a problem till now. I also looked at my files being saved and they are mostly mpeg files. I have 2 drives so once I start I just let it go and it usually finishes. Each file type has a symbol like the power dvd symbol next to it. Thank You for any help that you can give


    VTS
    MPEG File VTS
    IFO File

    Video_TS.BUP
    BUP File

    VTS
    MPEG File
  • jm1647
    An Eagles Fan, A MenuShrinker
    • Apr 2005
    • 3661

    #2
    If you upgraded to 6.6.1.4 download to 6.6.0.18, get it here.

    Comment

    • mac007
      Junior Member
      Junior Member
      • Apr 2006
      • 26

      #3
      Thanks Alot, used the clean tool, installed the 6.6.0.18 and everything is fine-----------------Thank You
      Last edited by mac007; 24 Jan 2007, 07:52 PM. Reason: Re-installed LightScribe----I get the TRF message again

      Comment

      • mac007
        Junior Member
        Junior Member
        • Apr 2006
        • 26

        #4
        Back to the drawing board

        I used the clean tool to remove 6.6.1.4. I installed 6.6.018. Everything was fine. I checked the nero version#, it was 6.6.018. I installed LightScribe, I checked the verson # of nero again and it went up to 6.6.1.4. I tried to burn with shrink and got the same trf message. Is there anything I can do. I have nero 6.3 bundled. I can re-install it. But will I have the same problems??????
        Thanks

        Comment

        • soup
          Just Trying To Help
          • Nov 2005
          • 7524

          #5
          Use the clean tool to remove Nero, then reinstall your bundle & then update to this. You could always use this version of Dvd Shrink that burns with ImgBurn but install ImgBurn first.

          Comment

          • mac007
            Junior Member
            Junior Member
            • Apr 2006
            • 26

            #6
            Finally Figured it out

            Nero 6.6.018 was fine. But after I installed LightScribe, the Nero version jumped back up to Nero 6.6.1.4. The solution is, when you are installing LightScribe, install everything on the disc, except the Nero. Everything is fine. Thank all of you for all of your help

            Comment

            Working...