Nero Coverdesigner Problem

[Mondas]

I am new to this forum and not sure if this is the right place to post my problem. I am using nero cover designer to make a DVD inlay for a case and everytime I print it up it always cuts it about 1/8 of an inch short and wants to print the rest on another sheet. have tried everything I can think of to fix it but nothing so far. I just can't seem to be able to move the image over to move the image over far enough to fit on the entire sheet. can anyone help please. this problem is driving me nuts.

BTW I burned a superfriends dvd and it played well but when I put a label on it, it began skipping and stopping. Does anyone know when I can do to stop this problem?

[LT. Columbo]

for part 2, don't use labels! it's a golden rule.

http://forum.digital-digest.com/showthread.php?s=&threadid=49635

[Mondas]

Can labelsreally cause that much of a problem? I have other discs that I put labels on and they play fine.

[LT. Columbo]

Can labelsreally cause that much of a problem? I have other discs that I put labels on and they play fine.

absolutely. search "labels" in the forum. it's common knowledge. most people (including me) will never come near them. (full disc labels). try to remove the labels that caused the playback issues.

[Mondas]

i just removed the labels from the discs and cleaned the sticky crap off of it and now it plays fine. Now if I can only figure out my printing problems. Thanks for the help.

[Mondas]

Again I tried everything I can think of and still nothing. During the print preview it shows that it will print correctly but still I get cut off.

[LT. Columbo]

i have never had a problem with that, and i don't use that feature anymore - sorry