burn using nero

[vik_pa]

i tried to burn a svcd (about 400MB) to a cd using nero. however after about 10 minutes i keep on getting the following

Buffer Underrun
Command Sequence Error
Could not perform end of Disk At Once
Burn process failed at 4 x (600KB/s)

???

[shiny#3]

it seems that your computer was not able to feed your writer fast enough with the required data......

if your writer is not buffer underrun proof give nero a higher amount of of ram to chache data ,...
do not run applications that require a lot of ram or a lot of HDD activity while burning.....


make sure that nero "finishes " a svcd... that means no multisession.......it should run in DAO mode!!

[vik_pa]

how do I give nero a higher amount of of ram to cache data, and how do I make sure that nero "finishes " an svcd.
also from the "write speed" drop down menu under the "burn" tab I only have 3 options with 4x(600KB/s) being the fastest option. I have seen screenshots of nero with 16x(2400KB/s). Is there anyway for me to enable faster write speed

[gd_nimrod]

Just make sure to leave your computer when its burning, so that it doesnt use those valuable resources on chatting, surfing, or whatever it is you may do while burning a disc.